巨箭聚丙烯PP胶水,粘PP塑料的胶水

景舜胶业-研发-销售-复合材料- (jingshun001.skxox.com)

巨箭的独家jukamPP>g-922

产品描述:聚丙烯巨箭jukam g-922 PP专用使用了专门用于PP塑料合成树脂单组分胶粘剂。

Product Description: Polypropylene giant arrow jukam g-922 PP special use for PP plastic synthetic resin single component adhesive.

Contact Mr. Yu:13416665501

无刺激气味,环保,无需处理材料表面,粘接后,可在室温下固化,定位时间适中,粘接强度高!良好的耐候性、耐酸碱性好!而且透明、无色,不影响产品的美观!常用于PP、塑料、金属、木材、石材、玻璃、陶瓷、布、皮革等材料的粘接。由于干燥时间适中,涂层性能良好,适用于中、大面积粘接!

No irritation odor, environmental protection, no need to deal with the surface of the material, after bonding, can be cured at room temperature, positioning time is moderate, high bonding strength! Good weather resistance, good acid and alkali resistance! And transparent, colorless, does not affect the appearance of the product! Commonly used in PP, plastic, metal, wood, stone, glass, ceramics, cloth, leather and other materials bonding. Due to moderate drying time, coating performance is good, suitable for medium and large area bonding!

操作说明:第一步:表面处理:表面处理,首先要去除材料表面的油或灰尘。.

第二步:施胶:分为单面双面施胶

施胶两种:单面胶(胶水要涂上稍微厚厚一层)使两侧加压紧密!

双面胶:双面涂(胶层可涂少许薄层),晾约5-8分钟,直至手接触胶体,粘手,但不拉伸合适,然后粘接,压紧,使两侧紧密贴合

单面双面涂胶及对比:单面胶可节省胶水,简化工艺,提高生产效率,但完全固化时间长,比双面胶粘合强度稍差。

第三步:固化:胶粘剂立即有一定强度,24小时完全固化,可做损伤试验!

Operating instructions: The first step: surface treatment: surface treatment, first of all to remove the material surface of the oil or dust. The

The second step: sizing: divided into single-sided double-sided sizing

Sizing two: single-sided adhesive (glue to be coated with a little thick layer) so that both sides of the pressure tight!

Double-sided adhesive: double-sided coating (glue can be coated with a little thin layer), dry for about 5-8 minutes until the hand contact colloid, sticky hand, but not stretched properly, and then bonding, pressing, so that both sides close Together

Single-sided double-sided adhesive and contrast: single-sided adhesive can save glue, simplify the process, improve production efficiency, but the full curing time is longer than the double-sided adhesive bonding strength slightly worse.

The third step: curing: adhesive immediately have a certain strength, 24 hours completely cured, do damage test!